IOT & Wireless
Showing all 19 resultsSorted by popularity
-
All Products, AI Thinker WiFi Module
ESP32 Camera Development Board WiFi+Bluetooth Module with OV2640 Camera Module Standard Quality
All Products, AI Thinker WiFi ModuleESP32 Camera Development Board WiFi+Bluetooth Module with OV2640 Camera Module Standard Quality
- Flash LED off: 180mA @ 5V.
- Flash LED on to maximum brightness: 310mA @ 5V.
- Deep-sleep: 6mA @ 5V min.
- Modem-sleep: 20mA @ 5V min.
- Light-sleep: 6.7mA @ 5V min.
SKU: IK-223 -
All Products, RF/NRF Module
3.3V Adapter Board for 24L01 Wireless Module
- It can be used with NRF24L01 wireless module
- Add core nRF24L01+ Breakout Adapter with onboard 3.3V Regulator
- Onboard 3.3V voltage regulator accepts your Arduino +5V supply and provides 3.3V for the attached nRF24L01+ module
- Allows for easy connection to nRF24L01+ modules
- Small power on SMD LED indicator
SKU: IK-141 -
All Products, RF/NRF Module
2.4GHz NRF24L01+PA+LNA SMA Wireless Transceiver Antenna
- Voltage: 3-3.6V (recommended 3.3V) V.
- Maximum output power: +20dBm.
- Power-down mode current: 4.2uA.
- Operating Range: 1Km
- Antenna Gain (peak): 2Dbi.
- 2MB rate (Open area): 520m.
- 1MB rate (Open area): 750m.
- 250Kb rate (Open area): 1100m.
- It uses 2.4GHz global open ISM band, with license free.
- SPI interface facilitates the communication with MCU I/O port.
SKU: IK-140 -
All Products, ESP8266 Boards
ESP8266 NodeMCU CP2102 Board
- Open-source, Interactive, Programmable, Low cost, Simple, Smart, WI-FI enabled
- Arduino-like hardware IO
- Integrated TR switch, balun, LNA, power amplifier and matching network
- Integrated PLL, regulators, DCXO and power management units
- Onboard USB to serial chip to easily program and upload codes from the Arduino IDE
- Embeds logic level converter circuits
- Has onboard 3.3V regulator to ensure enough power to function as your go-to WiFi chip!
- Easy access to the GPIO pins for easy prototyping
- ESP-12E Processor
- Easy to use breadboard friendly form factor
SKU: IK-102 -
All Products, Accessories, Accessories, AI Thinker WiFi Module, ESP Boards
USB TO UART TTL 5V 3.3V FT232RL Download Cable To Serial Adapter Module For Arduino Standard Quality
All Products, Accessories, Accessories, AI Thinker WiFi Module, ESP BoardsUSB TO UART TTL 5V 3.3V FT232RL Download Cable To Serial Adapter Module For Arduino Standard Quality
- Standard interface layout, compatible with a variety of Arduinos such as the Pro Mini
- Original FTDI FT232 chip, stable performance
- USB power has current protection, using 500MA self-restore fuse
- RXD/TXD transceiver communication indicator
- With power, sending, receiving indicator, working status LED indicators
- Mini USB Port Connection
- Support 3.3V, 5V
SKU: IK-146 -
All Products, GSM/GPS/GPRS
NEO-6M GPS Module with EPROM
- 5Hz position update rate.
- The cold start time of 38 s and Hot start time of 1 s.
- Configurable from 4800 Baud to 115200 Baud rates. (default 9600).
- SuperSense ® Indoor GPS: -162 dBm tracking sensitivity.
- Support SBAS (WAAS, EGNOS, MSAS, GAGAN).
- Separated 18 x 18mm GPS antenna.
SKU: IK-110 -
All Products, RFID/NFC
RFID 13.56MHz Card-3Pcs Standard Quality
- Contactless transmission of data and supply energy (no battery needed)
- Operating distance: Up to 100mm (depending on antenna geometry)
- Operating frequency: 13.56MHz
- Data transfer: 106 kbit/s
- Data integrity: 16 Bit CRC, parity, bit coding bit counting
- Anticollision
- Typical ticketing transaction: <100 ms ( including backup management)
SKU: IK-154 -
All Products, Accessories, Clock & Timer ICs, RFID/NFC
Real Time Clock RTC DS1307 Module AT24C32 without Battery Standard Quality
All Products, Accessories, Clock & Timer ICs, RFID/NFCReal Time Clock RTC DS1307 Module AT24C32 without Battery Standard Quality
- Two-wire I2C interface.
- Hour: Minutes: Seconds AM/PM.
- Day Month, Date – Year.
- DS1307-based RTC (Battery not include).
- 1Hz output pin.
- Available in 8-pin DIP or SOIC
SKU: IK-122 -
All Products, ESP Boards, ESP32 Boards, IOT & Wireless
ESP32 38Pin Development Board WiFi+Bluetooth Ultra-Low Power Consumption Dual Core
All Products, ESP Boards, ESP32 Boards, IOT & WirelessESP32 38Pin Development Board WiFi+Bluetooth Ultra-Low Power Consumption Dual Core
1. 2.4GHz Dual-Mode WiFi + Bluetooth Development Board, 38PIN
2. Ultra-Low power consumption works perfectly with the IDE
3. Support LWIP protocol, Freertos
4. Support Three Modes: AP, STA, and AP+STA
5. ESP 32 is safe, reliable, and scalable to a variety of applicationsSKU: IK-104 -
All Products, RFID/NFC
RFID Reader/Writer RC522 SPI S50 with RFID Card and Tag Good Quality
- Voltage:Â DC 3.3V (Do not use 5V supply)
- Operating Current :13-26mA
- Idle Current :10-13mA
- Operating Frequency: 13.56MHz
- Highly integrated analog circuitry to demodulate and decode responses
- Supports ISO/IEC 14443 A/MIFARE
- Typical operating distance in reading/Write mode up to 50 mm
SKU: IK-153 -
All Products, Accessories, AI Thinker WiFi Module, Miscellaneous
CP2102(6-pin) USB 2.0 to TTL UART serial converter
All Products, Accessories, AI Thinker WiFi Module, MiscellaneousCP2102(6-pin) USB 2.0 to TTL UART serial converter
- Brand new and high quality
- Included USB transceiver, without external circuit device
- With 3.3V and 5V dual power output
- With three LEDs: power indicator, data reception indicator, the data transmission indicator, working status
- Meets the USB2.0 specification requirements
- With self-recovery fuse. In the event of the accidental short circuit, it can effectively protect your computer USB port and Downloader
- Asynchronous serial data bus compatible with all handshake and modulation controller interface signals
- The supported data format is 8 data bits, 1 stop bit and parity bits
SKU: n/a -
Accessories, AI Thinker WiFi Module, All Products, Miscellaneous
CH340G USB To TTL(Serial) Converter For Arduino Nano Raspberry Pi
Accessories, AI Thinker WiFi Module, All Products, MiscellaneousCH340G USB To TTL(Serial) Converter For Arduino Nano Raspberry Pi
- Built-in USB to TTL Transfer chip.
- Designed to be used for USB to TTL electronic projects.
- TTL interface output, easy to connect to your MCU.
- Dual 3.3V and 5V Power output, work with 3.3v and 5 V target device.
- The mini-module is designed specifically for STC download and ARDUINO PRO supports all series of STC
- Supports WIN7/VISTA/MAC/LINUX(32 bit /64-bit system)
SKU: n/a -
All Products, RF/NRF Module
M177 NRF24L01 2.4GHz Antenna Wireless Transceiver Module
- Maximum operating speeds up to 2Mbps, GFSK modulation efficiency, Anti-interference ability,
- Particularly suitable for industrial control applications.
- Built-in hardware CRC error detection, Multipoint communication address control.
- Low-power 1.9 ~ 3.6V, only 1uA on Power down mode
- Built-in 2.4Ghz antenna
- Built-in voltage regulator
- Standard DIP Pitch Interface for embedded applications
SKU: IK-139 -
-
All Products, ESP Boards, ESP8266 Boards
ESP8266 Adapter Plate Serial Wireless WIFI Module
- It features reserved land-pattern for the 3.3V regulator
- It has Pinouts on the top layer in black colour.
- Compatible with Latest ESP-12F ESP8266 Wifi Module
- It includes a 10K pull-up resistor populated on PCB.
SKU: n/a -
All Products, ESP Boards, ESP8266 Boards
IoT Board Module ESP-12F ESP8266 Wifi Wireless at Best Price
All Products, ESP Boards, ESP8266 BoardsIoT Board Module ESP-12F ESP8266 Wifi Wireless at Best Price
- Communication interface voltage: 3.3V
- Working current: 240mA(MAX)
- Serial port baud rate: 115200 (default), can be modified to other values by AT command
- Serial communication format: 8N1
- Wireless Network Mode: station / softAP / SoftAP + station
- Wireless criteria: 802.11 b / g / n
- WIFI @ 2.4 GHz, support for WPA / WPA2 security mode
- +19.5dBm output power
SKU: IK-242 -
All Products, ESP Boards, ESP8266 Boards
Transceiver Module Esp-01 Esp8266 serial wifi Wireless Standard Quality
All Products, ESP Boards, ESP8266 BoardsTransceiver Module Esp-01 Esp8266 serial wifi Wireless Standard Quality
- 802.11 b/g/n Standards
- Wi-Fi Direct (P2P), soft-AP
- 1MB Flash Memory
- Integrated low power 32-bit CPU could be used as an application processor
- A-MPDU & A-MSDU aggregation & 0.4ms guard interval
- Wake up and transmit packets in < 2ms
- Standby power consumption of < 1.0mW (DTIM3)
SKU: IK-224 -
-
