Arduino
Showing all 7 resultsSorted by popularity
-
-
All Products, Arduino Boards
Arduino Uno R3 SMD Compatible Development Board(Without cable)
- Microcontroller ATmega328 (SMD) – Interface CH340G
- Operating Voltage: 5V
- Input Voltage (recommended): 7-12V
- Input Voltage (limits): 5-20V
- Digital I / O Pins 14 (of which 6 provide PWM output)
- Analog Input Pins: 6
SKU: IK-112 -
All Products, Arduino Boards
Arduino Nano R3 Compatible Board with CH340 chip(Unsoldered)
- Operating Voltage (logic level): 5V
- With Soldered Connector
- 8 analog inputs ports: A0 ~ A7
- 14 Digital input / output ports: TX, RX, D2 ~ D13
- 1 pair of TTL level serial transceiver ports RX / TX
- Using Atmel Atmega328P-AU MCU
- There is a bootloader installed in it
- Standard 0.1” spacing DIP (breadboard friendly).
- Manual reset switch.
SKU: IK-115 -
All Products, Arduino Boards
Arduino Uno R3 SMD Compatible Development Board(With cable)
- Microcontroller ATmega328 (SMD) – Interface CH340G
- Operating Voltage: 5V
- Input Voltage (recommended): 7-12V
- Input Voltage (limits): 5-20V
- Digital I / O Pins 14 (of which 6 provide PWM output)
- Analog Input Pins: 6
SKU: IK-268 -
All Products, Distance/Proximity, Force/Flex/Load, IR Proximity/Motion, Miscellaneous, Sensors
Tilt Sensor Vibration Alarm Vibration Switch Module for Arduino
All Products, Distance/Proximity, Force/Flex/Load, IR Proximity/Motion, Miscellaneous, SensorsTilt Sensor Vibration Alarm Vibration Switch Module for Arduino
-
Operating voltage: 3.3 to 5VDC
-
Ball Rolling type of tilt sensor.
- This small module is easy to use.
- A fixed bolt hole for easy installation
- Wide voltage LM393 comparator
SKU: IK-188 -
-
All Products, Arduino Kits, Custom Kits, Sensor Kits
37 in 1 Sensors Kit compatible with Arduino
- For beginners who are interested in Arduino
- A complete set of Arduino’s most common and useful electronic components
- Infrared sensor receiving module
- Laser sensor module
- Temperature and humidity sensor module
- Infrared sensor module
- 5v relay module
- Obstacle avoidance sensor module.
SKU: IK-101 -
All Products, Arduino Shields
L293D Motor Driver Shield For Arduino Standard Quality
- 2 connections for 5V ‘hobby’ servos connected to the Arduino’s high-resolution dedicated timer
- 4 H-Bridges: L293D chipset provides 0.6A per bridge (1.2A peak) with thermal shutdown protection, internal kickback protection diodes.
- Can run motors on 4.5VDC to 25VDC.
- Up to 4 bi-directional DC motors with individual 8-bit speed selection (so, about 0.5% resolution)
- Up to 2 stepper motors (unipolar or bipolar) with single coil, double coil, or interleaved stepping.
SKU: IK-133
