All Products
Showing 121–144 of 246 resultsSorted by popularity
-
All Products, Pressure/Touch, Sensors
BMP180 Digital Barometric Sensor Module compatible with Arduino
All Products, Pressure/Touch, SensorsBMP180 Digital Barometric Sensor Module compatible with Arduino
- 1.8V to 3.6V Supply Voltage
- Low power consumption – 0.5uA at 1Hz
- I2C interface
- Max I2C Speed: 3.5Mhz
- Very low noise – up to 0.02hPa (17cm)
- Fully calibrated
- Pressure Range: 300hPa to 1100hPa (+9000m to -500m)
SKU: IK-191 -
All Products, Distance/Proximity, Force/Flex/Load, IR Proximity/Motion, Miscellaneous, Sensors
Tilt Sensor Vibration Alarm Vibration Switch Module for Arduino
All Products, Distance/Proximity, Force/Flex/Load, IR Proximity/Motion, Miscellaneous, SensorsTilt Sensor Vibration Alarm Vibration Switch Module for Arduino
-
Operating voltage: 3.3 to 5VDC
-
Ball Rolling type of tilt sensor.
- This small module is easy to use.
- AÂ fixed bolt hole for easy installation
- Wide voltage LM393 comparator
SKU: IK-188 -
-
All Products, Sensors, Temperature
DS18B20 Water Proof Temperature Probe – Black (1m)
- A probe by new original installation import DS18B20 temperature sensor chip.
- Stainless steel tube encapsulation waterproof moistureproof prevents rust.
- Stainless steel shell (6 * 45 mm), lead length 100 mm (shielding wire) use stability;
- 3.0 V-5.5 V power supply;
- Temperature range wide: -55 ℃ ~ + 125 ℃;
- Without the external components, the unique single bus.
SKU: IK-179 -
All Products, Accessories, Accessories, Arduino, Development Boards, Miscellaneous, Sensors
ADS1115 16-Bit ADC- 4 Channel with Programmable Gain Amplifier Standard Quality
All Products, Accessories, Accessories, Arduino, Development Boards, Miscellaneous, SensorsADS1115 16-Bit ADC- 4 Channel with Programmable Gain Amplifier Standard Quality
- Wide Supply Range: 2.0v To 5.5v
- Low Current Consumption
- Continuous Mode: Only 150µa Single-shot
- Auto Shut-down
- Programmable Data Rate: 8SPS to 860SPS
- It has Internal low-drift voltage reference
SKU: IK-172 -
All Products, Battery, Battery Charger, BMS(Battery Management System), Li-ion Battery
5V Step-Up Power Module Lithium Battery Charging Protection Board USB For DIY Charger
All Products, Battery, Battery Charger, BMS(Battery Management System), Li-ion Battery5V Step-Up Power Module Lithium Battery Charging Protection Board USB For DIY Charger
- BAT Discharging Stop Voltage:2.9V
- Discharging Efficiency:85%(input 3.7V output 5V/1A)
- Charging and discharging indication
- Internally installed charging and discharging power MOS
- Preset 4.2V charging voltage, precision ±1%
- Max 8uA standby current
- Integration charging management and discharging management
- Intelligent temperature control and overtemperature protection
- Integration output overvoltage protection, short circuit protection, overload protection
SKU: IK-171 -
All Products, Battery, BMS(Battery Management System)
3 Series 20A 18650 Lithium Battery Protection Board 11.1V 12V 12.6V
All Products, Battery, BMS(Battery Management System)3 Series 20A 18650 Lithium Battery Protection Board 11.1V 12V 12.6V
- 3S 11.1V 12.6V 20A 18650 lithium battery protection board (comes with recovery function-AUTO Recovery).
- Application: Nominal voltage of 3.6V, 3.7V lithium battery (including 18650.26650, a polymer lithium battery).
- Continuous discharge current (upper limit): 20A (if the cooling environment is not good, please reduce the load current use).
- Continuous charge current (upper limit): 20A.
- Suitable for the drills with starting current below 80A, power below 135W
SKU: IK-170 -
-
-
All Products, IR Proximity/Motion, Magnetic/Vibration, Sensors
Best Vibration sensor module alarm Motion sensor module vibration switch SW-420
All Products, IR Proximity/Motion, Magnetic/Vibration, SensorsBest Vibration sensor module alarm Motion sensor module vibration switch SW-420
- Using SW-420 normally closed type vibration sensor
- Comparator output, clean signal, good waveform, strong driving ability, >15mA
- Operating voltage 3.3V ~ 5V
- Output format: digital switching output (0 and 1)
- Using a wide voltage LM393 comparator
- With bolt holes for easy installation
SKU: IK-165 -
All Products, Accessories, Arduino, Arduino Boards, Arduino Shields
I2C Bi-Directional logic Level Converter- 4 Channel
All Products, Accessories, Arduino, Arduino Boards, Arduino ShieldsI2C Bi-Directional logic Level Converter- 4 Channel
- Material: ABS + metal
- Dimensions: 16 x13 x 3 (L x W x H) mm
- Weight: 2gm
- Mutual transform between 5V TTL and 3.3V TTL
- Four channels of logic and high voltage low voltage logic can two-way transform
- Portable and lightness, with 2 rows 6 pin contact pins
SKU: IK-160 -
All Products, Audio Components, Sensors, Speaker
MP3-TF-16P MP3 SD Card Module with Serial Port
- Supports sampling rates (KHz): 8 / 11.025 / 12/16 / 22.05 / 24/32 / 44.1 / 48
- 24-bit DAC output, dynamic range support: 90dB, SNR support: 85dB
- Fully supports FAT16, FAT32 file system
- Maximum support 32G TF card
- Support U disk to 32G, 64M bytes of NORFLASH
- A variety of control modes are available. IO control mode, serial mode, AD key control mode
SKU: IK-158 -
All Products, RFID/NFC
RFID 13.56MHz Card-3Pcs Standard Quality
- Contactless transmission of data and supply energy (no battery needed)
- Operating distance: Up to 100mm (depending on antenna geometry)
- Operating frequency: 13.56MHz
- Data transfer: 106 kbit/s
- Data integrity: 16 Bit CRC, parity, bit coding bit counting
- Anticollision
- Typical ticketing transaction: <100 ms ( including backup management)
SKU: IK-154 -
All Products, Battery Charger, BMS(Battery Management System), Power Supply, Voltage Regulator
TP4056 1A Li-Ion Battery Charging Board Micro USB with Current Protection Standard Quality
All Products, Battery Charger, BMS(Battery Management System), Power Supply, Voltage RegulatorTP4056 1A Li-Ion Battery Charging Board Micro USB with Current Protection Standard Quality
- Dimension: 25 x 19 x 10 (LxWxH)mm.
- Input interface: micro USB.
- Current Protection: Yes
- Charging mode: Linear charging.
- Current: 1A adjustable.
- Charge precision: 1.5%.
- Input voltage: 4.5V-5.5V.
- Full charge voltage: 4.2V.
SKU: IK-152 -
-
All Products, Buck/Boast Converter, Power Supply
XL4015 5A DC-DC Step Down Adjustable Power Supply Buck Module LED with Heatsink Good Quality
All Products, Buck/Boast Converter, Power SupplyXL4015 5A DC-DC Step Down Adjustable Power Supply Buck Module LED with Heatsink Good Quality
- Input voltage range: 4V-38V DC
- Output voltage range: 1.25V-36V DC adjustable.
- Output current: 0-5A.
- Output power: 75W.
- High efficiency up to 96%
- The built-in thermal shutdown function
- Built-in current limit function
- In-Built output short protection function
SKU: IK-144 -
All Products, Accessories, Keyboard & Mouse, Pressure/Touch, Switches & Keypads
4×4 Matrix Keypad Membrane Switch for Arduino, ARM and other MCU
All Products, Accessories, Keyboard & Mouse, Pressure/Touch, Switches & Keypads4×4 Matrix Keypad Membrane Switch for Arduino, ARM and other MCU
- Ultra-thin design & adhesive backing provides easy integration to any project
- Excellent price-performance ratio
- Easy communication with any microcontroller
- 5 pins 2.54mm pitch connector, 4x 4type 16 keys.
- Sticker can peel off for adhesive mounting.
- Operating Voltage (V): 12 DC
SKU: IK-138 -
All Products, Accessories, Clock & Timer ICs, RFID/NFC
Real Time Clock RTC DS1307 Module AT24C32 without Battery Standard Quality
All Products, Accessories, Clock & Timer ICs, RFID/NFCReal Time Clock RTC DS1307 Module AT24C32 without Battery Standard Quality
- Two-wire I2C interface.
- Hour: Minutes: Seconds AM/PM.
- Day Month, Date – Year.
- DS1307-based RTC (Battery not include).
- 1Hz output pin.
- Available in 8-pin DIP or SOIC
SKU: IK-122 -
All Products, AC-DC Converter, Hi-Link Power Supply, Power Supply
Hi-link HLK PM12 12V/3W Switch Power Supply Module
All Products, AC-DC Converter, Hi-Link Power Supply, Power SupplyHi-link HLK PM12 12V/3W Switch Power Supply Module
- Meet UL, CE requirements,
- Ultra-thin, ultra-small
- All voltage input (AC: 90 ~ 264V)
- Low ripple and low noise
- Output overload and short circuit protection
- High efficiency, high power density
- The product is designed to meet the requirements of EMC and Safety Test
SKU: IK-108 -
All Products, AC-DC Converter, Hi-Link Power Supply, Power Supply
Hi-Link HLK 5M05 5V/5W Switch Power Supply Module
All Products, AC-DC Converter, Hi-Link Power Supply, Power SupplyHi-Link HLK 5M05 5V/5W Switch Power Supply Module
- Meet UL, CE requirements,
- Ultra-thin, ultra-small
- All voltage input (AC: 90 ~ 264V)
- Low ripple and low noise
- Output overload and short circuit protection
- High efficiency, high power density
- The product is designed to meet the requirements of EMC and Safety Test
- Low power consumption, environmental protection, no-load loss <0.1W
- Works without external circuit.
SKU: IK-107
