Subtotal: ₹60.00
All Products
Showing 1–24 of 246 resultsSorted by popularity
-
All Products, AI Thinker WiFi Module
ESP32 Camera Development Board WiFi+Bluetooth Module with OV2640 Camera Module Standard Quality
All Products, AI Thinker WiFi ModuleESP32 Camera Development Board WiFi+Bluetooth Module with OV2640 Camera Module Standard Quality
- Flash LED off: 180mA @ 5V.
- Flash LED on to maximum brightness: 310mA @ 5V.
- Deep-sleep: 6mA @ 5V min.
- Modem-sleep: 20mA @ 5V min.
- Light-sleep: 6.7mA @ 5V min.
SKU: IK-223 -
All Products, Current/Voltage, Voltage Regulator
Voltage Detection Sensor Module 25V
- You can also use the IICLCD1602 LCD to display voltage.
- By 3P connector, connect this module with the expansion of board Arduino
- Voltage input range: DC 0-25 V
- Voltage detection range: DC 0.02445 V to 25 V
- Voltage analog resolution : 0.00489 V
SKU: IK-150 -
All Products, Arduino Boards
Arduino Uno R3 SMD Compatible Development Board(Without cable)
- Microcontroller ATmega328 (SMD) – Interface CH340G
- Operating Voltage: 5V
- Input Voltage (recommended): 7-12V
- Input Voltage (limits): 5-20V
- Digital I / O Pins 14 (of which 6 provide PWM output)
- Analog Input Pins: 6
SKU: IK-112 -
-
All Products, Raspberry Pi, Raspberry Pi Boards
Raspberry Pi 4 Model B with 2 GB RAM Standard Quality
All Products, Raspberry Pi, Raspberry Pi BoardsRaspberry Pi 4 Model B with 2 GB RAM Standard Quality
- 2GB/4GB Varients
- Quad-Core 64-bit Broadcom 2711, Cortex A72 Processor
- WLAN 802.11 b/g/n/ac (2,4 + 5,0 GHz)
- LAN RJ45 10/100/1000 Mbit (Gigabit LAN over USB 3.0)
- Operating Power 5V@3A via USB Type-C Port
SKU: IK-243 -
All Products, Battery, Battery Holder
Cell Box/Black Plastic Storage Box Case Holder For Battery 3 x 18650, Without Cover Standard Quality
All Products, Battery, Battery HolderCell Box/Black Plastic Storage Box Case Holder For Battery 3 x 18650, Without Cover Standard Quality
- Hold 3 standard 18650 batteries.
- Wire Length: 15 cm.
- Output: 11.1 V.
- Dimension (Appro.) : 76 x 60 x 18 mm.
- Weight: 18 gm.
- High-quality plastic material
SKU: IK-213 -
All Products, Distance/Proximity, Miscellaneous, Potentiometer
M274 Rotary Encoder 360 Degree Brick Sensor Module Good Quality
All Products, Distance/Proximity, Miscellaneous, PotentiometerM274 Rotary Encoder 360 Degree Brick Sensor Module Good Quality
- Model : KY-040.
- Type : Incremental Encoder.
- Cycles per revolution (CPR) : 20.
- Working voltage : 0 – 5V.
- Material : PCB + Brass.
- Mounting Nut Thread diameter: 6.6mm
- Weight : 10 gm.
SKU: IK-175 -
All Products, Arduino Boards
Arduino Nano R3 Compatible Board with CH340 chip(Unsoldered)
- Operating Voltage (logic level): 5V
- With Soldered Connector
- 8 analog inputs ports: A0 ~ A7
- 14 Digital input / output ports: TX, RX, D2 ~ D13
- 1 pair of TTL level serial transceiver ports RX / TX
- Using Atmel Atmega328P-AU MCU
- There is a bootloader installed in it
- Standard 0.1” spacing DIP (breadboard friendly).
- Manual reset switch.
SKU: IK-115 -
-
-
All Products, RF/NRF Module
3.3V Adapter Board for 24L01 Wireless Module
- It can be used with NRF24L01 wireless module
- Add core nRF24L01+ Breakout Adapter with onboard 3.3V Regulator
- Onboard 3.3V voltage regulator accepts your Arduino +5V supply and provides 3.3V for the attached nRF24L01+ module
- Allows for easy connection to nRF24L01+ modules
- Small power on SMD LED indicator
SKU: IK-141 -
All Products, RF/NRF Module
2.4GHz NRF24L01+PA+LNA SMA Wireless Transceiver Antenna
- Voltage: 3-3.6V (recommended 3.3V) V.
- Maximum output power: +20dBm.
- Power-down mode current: 4.2uA.
- Operating Range: 1Km
- Antenna Gain (peak): 2Dbi.
- 2MB rate (Open area): 520m.
- 1MB rate (Open area): 750m.
- 250Kb rate (Open area): 1100m.
- It uses 2.4GHz global open ISM band, with license free.
- SPI interface facilitates the communication with MCU I/O port.
SKU: IK-140 -
All Products, Cables & Connector, Jumper Wires
Male to Male Jumper Wires 40 Pin 30cm Standard Quality
All Products, Cables & Connector, Jumper WiresMale to Male Jumper Wires 40 Pin 30cm Standard Quality
- 40P Color Jumper Wire
- Length: 400mm
- Weight: 56 gm
- Compatible with 2.54mm spacing pin headers
- 40pcs chromatic male to male color jump wire
- High quality and in good working condition
- Durable and reusable
- Easy to install and use
SKU: IK-136 -
All Products, Accessories, Motors & Mechanicals, Power Supply
L298n Motor Driver 2A Based Module – Good Quality
All Products, Accessories, Motors & Mechanicals, Power SupplyL298n Motor Driver 2A Based Module – Good Quality
- Current Sense for each motor.
- Heatsink for better performance.
- Power-On LED indicator.
- Double H bridge Drive Chip: L298N.
- Operating Voltage(VDC): 5~35
- Peak Current (A): 2
- Continuous Current (A): 0-36mA
- No. of Channels: 2
- Over-Current Protection (A): Yes
- Thermal Protection: Yes
SKU: IK-132 -
All Products, Light/Colour
LM393 Photosensitive Light-Dependent Control Sensor LDR Module
- LDR module 4 PIN
- Operating voltage 3.3V-5V
- Signal output indicator light.
- LDR module 4 PIN
- Able to detect ambient brightness and light intensity Adjustable sensitivity (via blue digital potentiometer adjustment)
SKU: IK-187
