Shop
Showing 217–240 of 248 resultsSorted by popularity
-
12v Relay, All Products
8 Channel Relay Module (with light coupling) 12V
- Operating Voltage: 12V DC
- Equipped with high-current relay 10A@250VAC / 10A@30VDC
- It can control both AC and DC appliances such as Solenoids, Motors, lights, fans, etc
- High-quality screw terminals (Terminal Block) provided (C, NC, NO) for quick and easy connection
- Freewheeling diode to protect your microcontroller
- Input Signal Pin connected to Burg stick for easy accessibility
- LED Status indicators to indicate the relay ON/OFF status
- Mounting holes provided
SKU: IK-249 -
All Products, Buck/Boast Converter, DC-DC Converter
150W DC-DC Boost Converter 10-32V to 12-35V 6A Step-Up Adjustable Power Supply
All Products, Buck/Boast Converter, DC-DC Converter150W DC-DC Boost Converter 10-32V to 12-35V 6A Step-Up Adjustable Power Supply
- Input voltage :10-32V
- Output voltage: 12-35V (adjustable)
- Output Current: 10A (MAX)
- Input Current: 16A (MAX) (Please enhance heat dissipation if more than 10A)
- The non-isolated step-up power conversion module
- Onboard LED illuminates when the voltage is applied to the module
- Equips Multi-turn Potentiometer.
SKU: IK-248 -
-
All Products, Stepper Motor/ Controller
16-Channel 12-bit PWM/Servo Driver I2C interface PCA9685 for Arduino Raspberry Pi
All Products, Stepper Motor/ Controller16-Channel 12-bit PWM/Servo Driver I2C interface PCA9685 for Arduino Raspberry Pi
- Adjustable frequency PWM up to about 1.6 KHz
- 12-bit resolution for each output – for servos, that means about 4us resolution at a 60Hz update rate
- Configurable push-pull or an open-drain output
- The output enable pin to quickly disable all the outputs
- Terminal block for power input
- Reverse polarity protection on the terminal block input
- Green power-good LED
SKU: IK-127 -
-
All Products, Motors/ESC/Controller, Servo Motor/Controller
Digital Multi Servo Tester ESC RC-1 Consistency CCPM Master Speed Control
All Products, Motors/ESC/Controller, Servo Motor/ControllerDigital Multi Servo Tester ESC RC-1 Consistency CCPM Master Speed Control
- Operating Voltage: DC 4.8-6V
- Offer 3 modes to check servos or ESC
- The Manual Mode allows you to turn the knob to different speeds and check the reaction time
- The Neutral mode makes the servo go back to the neutral point
- The Automatic ’’Window Wiper’’ Mode makes the servo swing like a window wiper in the largest angle possible
- Connect to up to 3 servos simultaneously
SKU: IK-128 -
-
All Products, Arduino Shields, Motor Drivers, Stepper Motor/ Controller
A4988 driver Stepper Motor Driver at Best Price
All Products, Arduino Shields, Motor Drivers, Stepper Motor/ ControllerA4988 driver Stepper Motor Driver at Best Price
- Supply Voltage : 8-35 VDC.
- Current : 1.0A Â (no heatsink ).
- Current : 2.0A (with heat-sinking).
- logic input : 3 – 5.5V .
- Automatic current decay mode detection / choice.
- Mixed with slow current decay mode.
SKU: IK-216 -
-
All Products, BO Motor
60 RPM BO Motor – Straight
- Low density: lightweight, low inertia.
- Capability to absorb shock and vibration as a result of elastic compliance.
- Ability to operate with minimum or no lubrication, due to inherent lubricity.
- The relatively low coefficient of friction.
- Operating Voltage(VDC): 3~12
- Shaft Length (mm): 8.5
- Shaft Diameter (mm): 5.5 (Double D-type)
- No Load Current: 40-180mA.
- Rated Speed(After Reduction): 100 RPM
- Rated Torque: 1 Kgcm
SKU: IK-208 -
All Products, BO Motor
100 RPM BO Motor- L Shape
- Low density: lightweight, low inertia.
- Capability to absorb shock and vibration as a result of elastic compliance.
- Ability to operate with minimum or no lubrication, due to inherent lubricity.
- The relatively low coefficient of friction.
- Operating Voltage(VDC): 3~12
- Shaft Length (mm): 8.5
- Shaft Diameter (mm): 5.5 (Double D-type)
- No Load Current: 40-180mA.
- Rated Speed(After Reduction): 100 RPM
- Rated Torque: 0.8 Kgcm
SKU: IK-210 -
All Products, RF/NRF Module
M177 NRF24L01 2.4GHz Antenna Wireless Transceiver Module
- Maximum operating speeds up to 2Mbps, GFSK modulation efficiency, Anti-interference ability,
- Particularly suitable for industrial control applications.
- Built-in hardware CRC error detection, Multipoint communication address control.
- Low-power 1.9 ~ 3.6V, only 1uA on Power down mode
- Built-in 2.4Ghz antenna
- Built-in voltage regulator
- Standard DIP Pitch Interface for embedded applications
SKU: IK-139 -
-
All Products, ESP Boards, ESP8266 Boards
ESP8266 Adapter Plate Serial Wireless WIFI Module
- It features reserved land-pattern for the 3.3V regulator
- It has Pinouts on the top layer in black colour.
- Compatible with Latest ESP-12F ESP8266 Wifi Module
- It includes a 10K pull-up resistor populated on PCB.
SKU: n/a -
All Products, ESP Boards, ESP8266 Boards
IoT Board Module ESP-12F ESP8266 Wifi Wireless at Best Price
All Products, ESP Boards, ESP8266 BoardsIoT Board Module ESP-12F ESP8266 Wifi Wireless at Best Price
- Communication interface voltage: 3.3V
- Working current: 240mA(MAX)
- Serial port baud rate: 115200 (default), can be modified to other values by AT command
- Serial communication format: 8N1
- Wireless Network Mode: station / softAP / SoftAP + station
- Wireless criteria: 802.11 b / g / n
- WIFI @ 2.4 GHz, support for WPA / WPA2 security mode
- +19.5dBm output power
SKU: IK-242 -
All Products, ESP Boards, ESP8266 Boards
Transceiver Module Esp-01 Esp8266 serial wifi Wireless Standard Quality
All Products, ESP Boards, ESP8266 BoardsTransceiver Module Esp-01 Esp8266 serial wifi Wireless Standard Quality
- 802.11 b/g/n Standards
- Wi-Fi Direct (P2P), soft-AP
- 1MB Flash Memory
- Integrated low power 32-bit CPU could be used as an application processor
- A-MPDU & A-MSDU aggregation & 0.4ms guard interval
- Wake up and transmit packets in < 2ms
- Standby power consumption of < 1.0mW (DTIM3)
SKU: IK-224 -
-
All Products, Accessories
Transparent Acrylic Case For Arduino UNO R3 at Best Price
- Protective case of Arduino Uno.
- Color: Transparent.
- Fastened by eight screws.
- Made by high grade acrylic.
- Provides excellent protection, with fashion appearance.
- Unique design for Uno with pin leakage, which provides easy connection to other components.
SKU: IK-222 -
All Products, Arduino, Arduino Boards
Arduino LilyPad 328 Main Board Standard Quality
- Microcontroller: ATmega168 or ATmega328V
- Operating Voltage: 2.7-5.5 V
- Digital I/O Pins: 14
- PWM Channels: 6
- Analog Input Channels: 6
- DC Current per I/O Pin: 40 mA
- Board will run from 2V to 5V.
- The latest version of the LilyPad supports automatic reset for even easier programming.
- The back side of the LilyPad is now completely flat!
SKU: IK-245
